The Forney 307 130FI 120-Volt Flux Cored/MIG wire welder is simple to operate and ready to weld. This machine welds mild steel, aluminum and stainless steel with correct wire and gas. The 306 MIG Welder has a Tweco(r) type welding torch. Also included in the box is a portable welding cart, face shield, combination chipping hammer/brush combination, welding torch, ground clamp and starter roll of flux cored welding wire. An automatic thermal overload protection will shut the machine down if the machine experiences a surge in power or any other problems from your power input. This machine is a gas/no gas unit that is easily converted for MIG (GMAW) welding. The max OCV for this unit is 30 VDC. The duty cycle is effective at 40-Percent at 60-Amps giving you 4 minutes of welding time on a 10 minute interval at 60-Amps. Your output range will run from 40-Amps to 130-Amps. This MIG welder uses the most popular sizes of welding wire including .024-Inch, .030-Inch and .035-Inch diameter. Weld thickness is 1/4-Inch (6.35 mm) mild steel. Weight is 53 pounds (24.04 Kg). The 5/3/1 or Advanced Replacement warranty is as follows, 5 years – Parts and Labor or Full Replacement: Transformer, 3 years – Parts and Labor or Full Replacement: All components and parts inside the battery charger or welder that cover within the exception of the transformer, 1 year – Parts and Labor (90 days for industrial use): All components and parts outside the battery charger or welder cover, included but not limited to cables, clamps. Switches, wheels and axle are not covered, 90 days: Replacement parts. Does not include labor.
Forney 307 130FI-A Gas/No Gas Flux Core Welder with 332 Cart, 120-Volt, 130-Amp, Green
Switch to our mobile site